Textured Roller with Handle
Textured Rolling Pins with handle capable of pressing a continuous repeated pattern on all kinds of sculpting putties, polymer clays, and pastes.
Made of clear PMMA plastic with amazing non-stick properties.
Their small size and the innovative design of their ergonomic handle make them an easy tool to transport and use.
There are different textures available that make them compatible with different modeling scales.
The textures are scalable to cover large surface areas. Also, its
handle allows us to print textures creating curves to give more realism
to the model or base.
Roller Width: 4 cm (1.5 inches)
Roller Length with Handle: 14cm (5.5 inches)
Diameter: 2'5cm (1 inch)
Scale: 54mm-Military (1/35-1/32)
* The textured rolling pins and their handles are presented unassembled. In the following
link there is a photo guide to help its assembly.
USE INSTRUCTIONS:
1st - Properly mix the putty/clay until ready according to the manufacturer's recommendations.
2nd
- Extend the putty/clay on a surface to be textured. For optimal
results, make sure you have got a smooth and even surface before
impressing with the Rolling Pins. *** We recommend using a plain Rolling
Pin for this.
3rd - Depending on the type of putty/clay, it is advisable to wet the Rolling Pin to prevent any sticking.
4th - Slowly move the Rolling Pin applying equal pressure at all points for an even texture.
5th
- Trim any excess putty/clay with a sharp knife. It is recommended to
do this once it has dried to avoid any deformations in the putty/clay.
FI / Finland
Lisää toivelistalle
